iTunes. NV+ V2 4bay's

Hello there,

My iTunes server has just stopped working after upgrading to 5.3.9 - I've tried to back port to older firmwares, but cannot get it to run again.

Hello mdgm, Is it possible to make another add on? like you did before in the post listed below? - It would be much appreciated and very helpful.

chirpa wrote:mdgm, time for you to make an addon that does this :P

Here you go: http://www.readynas.com/contributed/mdgm/addons/arm/ENABLEITUNESSERVER_1.0-arm.bin

Once you have installed this add-on you can go to http://ip.address.of.nas:3689 to configure the iTunes Server.


Thanks in advance and regards

What's wrong with the add-on that's there?

It could be that your set up needs a bit more attention than just being enabled, unfortunately. There are lots of details about db type etc in this thread.

I think on recent firmware changes are needed to the config file which wasn't the case when I wrote the add-on.

mdgm wrote:
chirpa wrote: mdgm, time for you to make an addon that does this :P Here you go: http://www.readynas.com/contributed/mdgm/addons/arm/ENABLEITUNESSERVER_1.0-arm.bin Once you have installed this add-on you can go to http://ip.address.of.nas:3689 to configure the iTunes Server.

Tried this addon on my NASDUO V2;ARM version 5.3.10, but it fails to install (?!?!?) Any suggestions as I really want to make this work

I had a go with the SSH but trying to log in the window disappears and that's it..... sure I am doing something wrong but this is a bit too complicated for me I am afraid

thx
Dee