Forum Discussion

Tutor

Apr 17, 2016

My ReadyNAS 214 wont shutdown -> do_exit+8c4

Hello community, I have a problem with my RN214. It`s not shutting down properly. It makes no difference if I do it from the webgui nor with the power bottom. After a few seconds it shows "do_exit...

NETGEAR Employee Retired

Apr 18, 2016

Hi Kalle13,

Welcome to the community!

Would you mind if you will try to break the bond and just use on active NIC in your ReadyNAS? Also, tell us if you have power timer scheduled on your device.

Kind regards,

BrianL
NETGEAR Community Team

Kalle13
Tutor
Apr 18, 2016
Hi BrianL,

thank you for your reply. I know what you are thinking, but this feature is important to me. Not because I need it, it' s just because I want to have it.:smileyvery-happy:
But why is it that way, just because I use an bond option the NAS won' t shutdown? In my opinion these features are not good implemented.
You are right. Until yesterday this "power timer" option was checked. Now I will try if this option was the case.

Best regards
Kalle
- Kalle13
  Tutor
  Apr 18, 2016
  I have tried it with the unactivated power option but no success.
  It won' t shutdown properly.
  
  Best regards
  Kalle
  - StephenB
    Guru - Experienced User
    Apr 18, 2016
    FWIW, forcing the power down by removing the power cord is not ideal, there is some risk to your data every time you do it.
    
    Does your switch support LACP? If it does, you would have needed to set it up on the switch.
    
    Either way, I suggest you do a test w/o the bond, and at least determine if removing it resolves the problem (or not).