Post your performance results

edmebba wrote:

edmebba wrote: PC: Dell XPS 400 CPU Pentium D 2.80Ghz Memory 3.25G Network Equipment: Dlink DGS-1008D* ( 10/100/1000 No JF support? The D-Link user manual says otherwise but it's on the Infrant HDW Incompatibility list. ) * Will post results after getting a D-Link DGS-1005D that supports JF. Network Topology: Dell ------ D-Link------Infrant Intranet-----| NAS Configuration: Infrant ReadyNAS NV+ Version: RAIDiator v3.01c1-p2 [1.00a032] Memory: 256MB [2.5-3-3-7] RAID X-RAID Redundant Disk Write Cache enabled Full Data Journaling Disabled Fast CIFS writes Enabled Disks 4-500GB Hitachi "Deathstars" ( HDS725050KLA360 ) Results: 1000Mbit JF Off Sectors: 2048000 Write MBps: 15.670103 Write Iops: 62.680412 Read MBps: 28.604001 Read Iops: 114.416004 Sectors: 8192000 Write MBps: 15.180526 Write Iops: 60.722104 Read MBps: 28.140746 Read Iops: 112.562983 1000Mbit JF On Sectors: 2048000 Write MBps: 7.444973 Write Iops: 29.779891 Read MBps: 23.555285 Read Iops: 94.22114 Sectors: 8192000 Write MBps: 7.320481 Write Iops: 29.281924 Read MBps: 24.238073 Read Iops: 96.952293 Thanks EDM Got the D-Link DGS-1005D and got the same numbers, any sugestions? I do not see a direct way to set host system to use Jumbo frames, according to the Users guide I just need to make sure the Intel Pro Set utility is being used, which it is. The Intel host system card is a Intel Pro/1000 PL. The host system that is running Iometer and the Ready NAS are plugged directly into the D-Link DGS-1005. EDM