NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
RAIDar can see Duo 1 but cannot access it
I have a Duo 1 with the latest firmware which has be working fine until yesterday evening when I went to look at the files using Windows 7 it said it could not connect to it. I had been working ok abo...
Do you definitely have a v1?
http://www.rnasguide.com/2012/01/09/how ... -or-nv-v2/
Do you have a backup?
Did you have ssh enabled?
Have you received any messages about disk errors?
Firstly I would power down, remove each disk and test it using vendor tools long/extended tests. Remember which disk goes in which slot. Once tested, put them both back in before powering on again.
If you have ssh enabled you can also ssh in and check the OS partition fullness using:
df -i
df -h
Post the results if you are not sure.
http://www.rnasguide.com/2012/01/09/how ... -or-nv-v2/
Do you have a backup?
Did you have ssh enabled?
Have you received any messages about disk errors?
Firstly I would power down, remove each disk and test it using vendor tools long/extended tests. Remember which disk goes in which slot. Once tested, put them both back in before powering on again.
If you have ssh enabled you can also ssh in and check the OS partition fullness using:
df -i
df -h
Post the results if you are not sure.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
