NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
RAIDar cant see ReadyNas
Running Windows 10. Just got used RN204. Connected directly to computer. IPscan show it is on ip 192.168.1.1 Tried to log into with firefox 45.0.2, wont connect. RAIDar says no netgearnas found....
old1mike wrote:
Had 4 2TB OEM 7200 drives. Took out 3 of them. Same issue. Like the unit, would like to get it working.
Are you saying that you had these drives in the NAS, and you just removed them? That will destroy the raid volume.
Why did you remove the drives?
old1mike wrote:
Running Windows 10..
Connected directly to computer.
IPscan show it is on ip 192.168.1.1
Normally the NAS is connected to your router, not the computer. Is there a reason you can't do that?
In addition to confirming the NAS IP address (using jak0lantash's suggestion) can you tell us what IP address the Windows PC is using?
Did have it hooked to router. Router did see and assigned IP. RAIDar could not find it. Tried putting IP in firefox. Would not connect. Did have Buffalo NAS - broken- and had hooked straight to computer to config. Thought I would try same. 192.168.1.1 is NETGEAR nas. Have IPscanner, shows it as netgear. The lan have hooked to is 192.168.2.1 subnet 255/255/0/0 with no dhcp.
With unit powerd up the power button is blue, drive1 on (only 1 hd in unit at this time), lan light green, LCD panel at bottom all boxes, nothing displayed.
If I press power button once (not holding it) unit powers off.
when you directly connected it to your PC, did you set the PC to a 192.168.1.x address?
For instance, 192.168.1.2, subnet mask 255.255.255.0 gateway 192.168.1.100
No. Not sure why I would do that. The lan is normally not used unless I need to connect something directly for configure or transfer. For internet access I am wireless. Initially ip was 192.168.1.1. When I plugged in ReadyNas windows complained of two devices with same hardcoded ip's. So i configured lan to be different then ran IPscanner. That when say netgear 192.168.1.1. Issue is, I dont think OS is running in the readynas. The LCD panel is all solid boxes. I know the LCD is working correctly as when first powered on do get standard greeting 'welcome to readynas' or something like that. Then goes to all lit up - aka boxes.
I noticed when first powered on goes through startup sequence where LCD is all 'boxes', then goes out and welcome message comes on then goes back to all lit up. Also, know LCD and electronics driving it are working properly. Am able to put in 'boot menu' mode, and the text is clear and fine. Just cant go any further.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
