Forum Discussion

Aspirant

Oct 20, 2016

ReadyNAS 6.6 on 204 - stop working :-(

Hi to everyone.

I received a bad news today. I wnt back to home and I found the readynas freezed with a "_309 out of memory" in the LSD.

I transfered a lot of file with RSYNC from the 204 (backup job owner) to a 202 (RSYNC server).

I have 4x3TB HD so I transfered only few parts of my data. The NAS was only with PLEX but in OFF position because it was not working after the ReadyNAS upgade to 6.6.

When I rebooted (unplugged and plugged again) It works for a while, just the time to enter via WEB and to check if everything seems ok, and it freeze! :-(

I tryed 3-4 time... I turned of ReadyDLNA and removed PLEX.

it now works... boot, 1 minute and it freez. No error message. LCD off. No blinking lights :-(

I really don't know what to do... I have to much media files to backup and reset with a fresh Install.

21 Replies

Replies have been turned off for this discussion

mdgm-ntgr
NETGEAR Employee Retired
Oct 20, 2016
Out of Memory would suggest a memory leak of some kind. I have sent you a PM.
- Kicco
  Aspirant
  Oct 21, 2016
  I'm going to read it. Thanks.
  
  PS: If there's a way, I can reset the NAS and configure it again in few minutes. My priority is to retain the data on disks (6 TB).
  - mdgm-ntgr
    NETGEAR Employee Retired
    Oct 21, 2016
    Does it come up fine if you boot it into volume read-only mode (a boot menu option)?
    
    If so can you download the logs and send the zip file in (see the Sending Logs link in my sig)
StephenB
Guru - Experienced User
Oct 20, 2016
Can you get in long enough to enable ssh?

Also, does it respond to ping after it freezes? How about RAIDar?
- Kicco
  Aspirant
  Oct 21, 2016
  RAIDar can find it in booting state and in active... after a while (less than a minute) it cannot find the NAS.
  I can try to enable the SSH but I'm not sure I can do something.