NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
ReadyNAS 628 stuck at "NETGEAR Storage Welcome" during 6.9.0 update
ReadyNAS 628 is stuck at "NETGEAR Storage Welcome" during 6.9.0 update attempt. Did not appear to completely update firmware before disconnecting from network. Same thing happened with 628 during previous 6.8.0 update, but not during 6.8.1 update. Did not recover from 6.8.0 problem until turning 628 on after four month shutdown. ReadyNAS Ultra 6 Plus update through 6.8.1 without any problem. What do I do to get 628 back up and running without a four month shutdown? Why do the 62X models (another thread has similar issues with a 626) have major version update issues?
Netgear replaced the ReadyNAS 628 under warranty. Installed labeled drives from original NAS in replacement 628, firmware update finished from where it left off, and the NAS booted normally. Hope the replacement 628 ends up as reliable as a ReadyNAS Ultra 6 Plus continues to be.
12 Replies
Replies have been turned off for this discussion
Did you try a forced shutdown and reboot? What status is RAIDar reporting?
FWIW, my RN52x NAS both upgraded with no problems.
So far, ReadyCLOUD reports 628 is offline, and RAIDar also only discovers the Ultra 6 Plus, not the 628, which is connected to the same switch as the U6P and a Mac mini used for access. Forced shutdowns and reboots using the power button on either the front or rear with either the eight data drives in place or a single blank drive returns to the same "NETGEAR Storage Welcome" message without booting.
The 628 had exactly the same behavior and issue a few months ago when the 628 was upgraded from 6.7.4 to 6.8.0. (The 6.8.1 upgrade was routinely successful.) Restarting after a four month shutdown, the 628 finally spontaneously and "auto-magically" finished the firmware update to 6.8.0 and resumed normal operation until the 6.9.0 upgrade attempt. During each major version upgrade (6.8.0 and 6.9.0), the firmware update seems to take much longer than usual before the 628 becomes disconnected from the network during the update progress (e.g., much longer than the 6.7.X and 6.8.1 updates).
At the moment, I have removed and labeled the eight data drives in the 628 and replaced them with one blank drive, and since that hasn't done anything, the 628 is turned off.
What apps are installed? Did you do anything with ssh?
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
