NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
ReadyNAS LED patterns
http://www.readynas.com/forum/faq.php#What_does_this_light_pattern_mean%3F_%28LED%29 Check our FAQ, HCL and more
- Until I post the FAQ, here is the info for reference:
LED blink behavior for 2 disk systems is three quick blinks of all disk LEDs and the backup LED, followed by an 1s delay, followed by a number of slow blinks. The number of slow blinks will be the error code.
Current error codes:
1 - Vendor mismatch
2 - No disks detected
3 - Bad contents on root partition of disks
4 - Flash error
5 - Unsupported RAID configuration
hi
i have a 312 that cannot operate now
it was running ok and then the 2 hard disks stopped with 2 lights on, namely the power and disk 1.
so i tried to do factory reset but the hard disks not spinning, fan is on and the unit just freeze with power light on and disk 1 led on only. that has been done many times. same result the unit just does not boot up.
took out the 2 hard disks and checked, put them into my old trusty duo v2 and factory reset, installed and running ok. so the hard disks are functional.
is the 312 dead with hardware malfunction? or firmware corrupt? it has 6.2.0 installed.
i have a 312 that cannot operate now
it was running ok and then the 2 hard disks stopped with 2 lights on, namely the power and disk 1.
so i tried to do factory reset but the hard disks not spinning, fan is on and the unit just freeze with power light on and disk 1 led on only. that has been done many times. same result the unit just does not boot up.
took out the 2 hard disks and checked, put them into my old trusty duo v2 and factory reset, installed and running ok. so the hard disks are functional.
is the 312 dead with hardware malfunction? or firmware corrupt? it has 6.2.0 installed.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
