NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.

Forum Discussion

Tutor

Oct 22, 2020

Solved

ReadyNas Pro6 will not start

After a power outage, it will not start. It only show "readynas" in display. Have tried another PSU that are OK. I have upgraded to 6.10.

What options do I have?

StephenB
Oct 26, 2020
nautic_no wrote:

At last it worked!

Good to hear!

39 Replies

Replies have been turned off for this discussion

JohnCM_S
NETGEAR Employee Retired
Oct 22, 2020
Hi nautic_no,

Is the NAS still detected on RAIDar?

If it is not detected by RAIDar, you can try removing the disks and see if you will get the same behavior on the NAS. (Note: Label the disks with its corresponding bay before removing them from the NAS)

Regards,
- StephenB
  Guru - Experienced User
  Oct 22, 2020
  JohnCM_S wrote:
  
  (Note: Label the disks with its corresponding bay before removing them from the NAS)
  
  And of course power down the NAS before removing them.
- nautic_no
  Tutor
  Oct 22, 2020
  Hi!
  As long as the device is not started not net and no raidar. Lan is not active, no net.
  I have tried that width no luck. Fans spinning up. Led1 contant red. Will not reset or start. Just ReadnyNAS in display. Is it supposed to take a while? Is there an other way to start?
  - nautic_no
    Tutor
    Oct 22, 2020
    When hold reset down while power up, boot menu is suposed to appear in display. But it do not. Is the reset button faulty? Some advice to clean every connector including CPU and memory. Is that something I should try?
    
    Best regards
    Ole Simen

NETGEAR Academy

Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!

Join Us!

ProSupport for Business

Comprehensive support plans for maximum network uptime and business peace of mind.