NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
ReadyNAS Ultra 2
Hello, sorry for my bad English!
I bought a ReadyNAS Ultra2, which was running fine!
But then I had to factory reset it, because I planned on using it another place.
I logged in to the NAS and made a factory reboot from the WebUI.
But then things started to get wierd.
The device wont boot up properly now.
Then i tried factory resetting it from the device itself, by following this guide:
http://www.readynas.com/kb/faq/boot/how_do_i_use_the_boot_menu
But when i turn on the device, the following LEDS are static on:
POWER
ACT
LED1
LED2
But if i try resetting it from the device itself, i can find it using RAIDiator where it gets an IP and all is good.
But i can only press "Setup".
So when i do that, and choose to make a new RAID config with 2 x 2TB discs in RAID 1. After that it is saying "installing" and thats good. After 1-2 minutes RAIDiator drops the connection the the NAS, and then i cannot connect to it again, unless i reset it(factory).
Any thoughts of what I can do?
I've uploaded some images of the NAS and the LEDS here:
http://s27.postimg.org/9otpjx0aa/2014_02_25_13_44_34.jpg
http://s28.postimg.org/sqnd1vyrg/2014_02_25_13_44_55.jpg
http://s21.postimg.org/fs0g4izye/2014_02_25_13_45_09.jpg
I bought a ReadyNAS Ultra2, which was running fine!
But then I had to factory reset it, because I planned on using it another place.
I logged in to the NAS and made a factory reboot from the WebUI.
But then things started to get wierd.
The device wont boot up properly now.
Then i tried factory resetting it from the device itself, by following this guide:
http://www.readynas.com/kb/faq/boot/how_do_i_use_the_boot_menu
But when i turn on the device, the following LEDS are static on:
POWER
ACT
LED1
LED2
But if i try resetting it from the device itself, i can find it using RAIDiator where it gets an IP and all is good.
But i can only press "Setup".
So when i do that, and choose to make a new RAID config with 2 x 2TB discs in RAID 1. After that it is saying "installing" and thats good. After 1-2 minutes RAIDiator drops the connection the the NAS, and then i cannot connect to it again, unless i reset it(factory).
Any thoughts of what I can do?
I've uploaded some images of the NAS and the LEDS here:
http://s27.postimg.org/9otpjx0aa/2014_02_25_13_44_34.jpg
http://s28.postimg.org/sqnd1vyrg/2014_02_25_13_44_55.jpg
http://s21.postimg.org/fs0g4izye/2014_02_25_13_45_09.jpg
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
