NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Upgraded PRO 6 to 6.5.1, had fan problems, went back to 6.5.0 and all is well again
Hi, After having succesfully used 6.5.0 on my PRO 6 since the day it came out, I upgraded to 6.5.1 today. The system fan started to act weird. When putting the fans on COOL, it took a little whi...
As for me there is no difference between 6.5.0 and 6.5.1
Would be better to get logs on firmware where you are running into the problem. Logs on a firmware where you are not having issues are of little value.
I'm having issues in both builds. If I run the CPU fan off the CPU fan header it will run at maximum speed. If I put it on the spare system fan header it will either run slow and not spin up when the CPU gets hot or fluctuate wildly. If I edit /etc/sensors.d/system.conf as I have shown on the previous page with fan3 labled as 'CPU' it will run it at maximum speed again.
At the moment it seems to have settled down somewhat but I cannot be sure it will stay that way,
I installed the latest beta (652 T486).
It had the fan issue.
Started the recovery to factory settings.
Still has the fan issue.
Thanks for checking and letting us know that you still see the issue on 6.5.2 Beta.
Hi mdgm,
i'm having the same problem on my readynas pro business running OS 6.5.2 "Fan System in enclosure Internal speed is below threshold. (340 rpm)." i will collect the logs and send them.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
