Write Speed ReadyNAS 102

What version of ReadyNAS OS are you running?

What disks do you have installed?

What services do you have enabled?

Are you using the anti-virus feature?

Are you using snapshots?

What apps are installed and running?

Hello

In response to your questions please see below:
What version of ReadyNAS OS are you running?
6.1.8

What disks do you have installed?
2 x WD 3TB Red SATA 6Gb/s 64MB 3.5" Hard Drives

What services do you have enabled?
Smb, AFP, readydlna, upnp, http and https

Are you using the anti-virus feature?
No

Are you using snapshots?
Yes

What apps are installed and running?
None

All settings are as they were on day one.

I hope this info helps. Thanks.

How are you measuring the speed?

Have you checked the SMART stats on the two disks?

Write speed should be about 50 MB/s (~400 mbits) btw.

I am using Lan Speed Test to measure the speed.

Please advise how I check the SMART stats?

Thanks.

download the logs and look at disk_info.log

Thanks. The logs look okay to me:
Device: sda
Controller: 0
Channel: 0
Model: WDC WD30EFRX-68EUZN0
Serial:
Firmware: 80.00A80
Class: SATA
RPM: 5400
Sectors: 5860533168
Pool: data
PoolType: RAID 1
PoolState: 1
PoolHostId: e353a50
Health Data:
ATA Error Count: 0
Reallocated Sectors: 0
Reallocation Events: 0
Spin Retry Count: 0
Current Pending Sector Count: 0
Uncorrectable Sector Count: 0
Temperature: 40
Start/Stop Count: 9
Power-On Hours: 1089
Power Cycle Count: 9
Load Cycle Count: 3

Device: sdb
Controller: 0
Channel: 1
Model: WDC WD30EFRX-68EUZN0
Serial:
Firmware: 80.00A80
Class: SATA
RPM: 5400
Sectors: 5860533168
Pool: data
PoolType: RAID 1
PoolState: 1
PoolHostId: e353a50
Health Data:
ATA Error Count: 0
Reallocated Sectors: 0
Reallocation Events: 0
Spin Retry Count: 0
Current Pending Sector Count: 0
Uncorrectable Sector Count: 0
Temperature: 40
Start/Stop Count: 9
Power-On Hours: 1086
Power Cycle Count: 9
Load Cycle Count: 3

Does anything here seem like a cause for concern?

These numbers look fine.

BTW, I edited out the serial numbers.

How full is the disk?

Are you testing from Windows? If so, try NasTester (http://www.808.dk/?code-csharp-nas-performance)

Hello the drives are about half full. this has been the speed since the beginning. All testing has been done in a Mac OS X environment as my Windows machine is rather old and I've had a pig of a time trying to get it to work in Windows.

Any other ideas or do you think it's a call to tech support?

thanks for removing the serial numbers by the way :)

Contacting support is reasonable.

I'd also try manually timing the transfer of a large file to see how that number compares with lan speedtest.

Also, try testing both smb and afp.

When did you purchase the 102? If over 90 days ago you should open an online case. Basic phone support is free for the first 90 days after purchase.