Set up mesh on WAX 628 without need for insight subscription

Feature request 
On wax 628 after 4 year subscription ends we should be able to amend mesh mode as currently it can only be done via insight. So after 4 years if you had to factory set the ap for what ever reason what you are saying is i have to pay subscription fee to have access to a basic setting which should be accessible regardless because this setting is a bare necessity for having multiple ap's and the main reason to have bought these pieces of equipment. You should not be held ransom for access to this basic necessity. This feature should be added to the next firmware update like for example accessing it via device ip address configurations

Currently to be able to mesh multiple ap's you have to go to mesh topology on the insight app to change mesh mode to auto, root , extender or disable.

After 4 years if this stays the same I have to subscribe per unit to be able to have access to this basic setting which is utterly ridiculous if you think about it.  If you were to factory reset or for whatever reason need to change the mesh mode you couldn't without ponying up.

So after 4 years my equipment is redundant because it wouldn't serve me the purpose for which they were bought for. 

So this should be added and available to access in the device IP access configuration page via local network