- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
WC7520 'bricking" WNDAP360 - How to recover the AP ?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
HI,
I have an issue with my EoL WC7520 has 'bricked' a WDNAP360 that it tried to update the firmware on. There are a numer of threads on this already but they often state 'and i recovered the WDNAP360 via the console' - please can somone direct me to a walktrough of how to do that bit!
Thanks in advance.
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: WC7520 'bricking" WNDAP360 - How to recover the AP ?
Thanks, that is useful. Do I take it that what appears to be a second Ethernet port is the RS232 port?
The WC7520 is at the latest (last) firmware.
Regards,
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: WC7520 'bricking" WNDAP360 - How to recover the AP ?
The port next to the factory reset hole is the console port. Make sure that you set the following settings before you access the WNDAP360 via console: 9600 K default baud rate, (8) data bits, no (N) parity bit, and one (1) stop bit.
As reference, kindly check pages 12-13 of the WNDAP360 Reference Manual here.
Regards,
DaneA
NETGEAR Community Team