- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
DGN2200v3 cannot sync (fw 1.1.00.25)
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
DGN2200v3 cannot sync (fw 1.1.00.25)
Hello,
my ISP is fastweb and i live in Italy.
When i connect my dgn2200v3 DSL LED flashes with Green color and can't synchronize.
I tried to set parametres (LLC-Based, 8, 36, auto) but it does not work.
If i use another router (as supplied by fastweb) the led are ok and i can connect.
I even tryed this by manual:
"If your ADSL link LED is blinking green, then your modem router is attempting to make an ADSL connection with the service provider. The LED should turn green within several minutes.
If the ADSL link LED does not turn green, disconnect all telephones on the line. If this solves the problem, reconnect the telephones one at a time, being sure to use a microfilter on each telephone. If the microfilters are connected correctly, you should be able to connect all your telephones.
If disconnecting telephones does not result in a green ADSL link LED, there might be a problem with your wiring. If the telephone company has tested the ADSL signal at your network interface device (NID), then you might have poor-quality wiring in your house."
but it does not work.
What do you think the problem is?
Why with other router (supplied by ISP) internet works and with netgear not?
Sorry for my bad english.
Regards
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: DGN2200v3 cannot sync (fw 1.1.00.25)
Hello shadeV
Did you ever get the modem working?
DarrenM
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more