- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
DGND3700v2 Firmware corrupt during update
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
DGND3700v2 Firmware corrupt during update
hi all,
during update firmware of my DGND3700v2 something goes wrong.
So now when I power on my router, the power led remain red.
Searching on internet I found this link:
http://kb.netgear.com/app/answers/detail/a_id/19841/~/reinstall-the-firmware-on-a-router-without-the...
So I powered off my router.
I pushed the Factory reset button and I powered on holding it down.
Now power led and DSL led blink alternatively (power led red and DSL led green).
I connected the lan cable to my pc, setted the static ip address (192.168.0.2 and 192.168.1.2, subnet mask 255.255.255.0 and gateway 192.168.0.1 and 192.168.1.1) but nothing. router doesn't respond to ping.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: DGND3700v2 Firmware corrupt during update
Sounds like unit has bricked.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: DGND3700v2 Firmware corrupt during update
I have the same problem as posted here.
Is there a way to un-brick the router?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: DGND3700v2 Firmware corrupt during update
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: DGND3700v2 Firmware corrupt during update
had trouble where the power light was solid red. Luckily old router still worked so connected that again After a couple of hours on Google tryed this http://kb.netgear.com/app/answers/detail/a_id/22688 but still had no luck
This did work though.
Down loaded the firmware for my DGND3700v2 from Netgear un zipped. Disconnected old router, connected DGND3700v2 with ethernet cable & opened internet browzer. typed in 192.168.0.1 message came up about updating firmware. browsed for the firmware that I had already down loaded. Clicked on OK.
After the update had finished I could not log into the router, turned the power off & on, plugged the phone line back in now it works fine. Did not even have to set the router up again.
I only know a bit about the internet & computers so sorry if you need to fill in the gaps.
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more