GS305EP trunk ALL

[tonynsx]

I have a GS305EP PoE managed switch.  First of all, the switch GUI looks different from what I'm used to from other Netgear managed switches.

My question is, when I do Trunk, I have option to trunk 'ALL' vlans, but how do I trunk just 1 VLAN?

I know I can use access port to select a VLAN, but I want to Trunk 1 single VLAN.

Example:

On this 5 port switch, I have VLAN 1,4

So on port 5, which is my uplink, I have Trunk set to ALL so I get VLAN 1,4

But on port 4, I also want to do Trunk, but just VLAN 4, how do I do that?

https://www.netgear.com/business/wired/switches/plus/gs305ep/ 

Also, I'm able to get to the webui using IP address, but I'm not seeing this on the Smart Control Center.  I see my older Netgear switches. And this switch is on the same LAN as my older Netgear switches.

[JeraldM]

Hi @tonynsx,

Just to confirm, have you referred to this KB article on section "Add ports to the VLANs"?

As for the Smart Control Center, the mentioned software is already end-of-life and so we recommend using either the ProSAFE Plus Configuration Utility (download link here) or the NETGEAR Switch Discovery Tool (link here).

Regards,

JeraldM

NETGEAR Community Team

[tonynsx]

@JeraldM 

Thank you, 

It turned out I was using the wrong VLAN mode, it works now.

Thanks for the switch discovery tool.