PXE Boot using lacp dynamic (port in indivual state)

We are trying to correctly setup port-channels for our cloud server farm that would use linux with bonding mode=4 (802.3ad). Once installed everything work as expected when using dynamic port-channels but that same configuration on the switches make impossible to reinstall them through pxe or change the bonding mode on servers according to node's role (hpc node = mode 0/6 or cloud node = mode 4)

If we use instead static port-channels all bonding modes work although (mode=4 802.3ad) only sees/uses one active port which is not desirable.

We've been playing with differente combinations of lacp actor/partner admin state (individual/passive/longtimeout) without success. Is it possible such combination with Netgear switches? The switch is in fact a stack of six M5300-52G ProSafe 48-port Gigabit L2+ with 10 Gigabit Stacking, running 11.0.0.12

Other vendor switches are able to cope with this, Juniper EX series using "force-up", Cisco/Nexus with "no lacp suspend-individual" which is the default, HP/H3C as well, specifying lacp edge-port...

So, the question is, is it possible? and if so, what's the configuration for such setup? Ideally we would like they were dynamic port-channels and if the switch/stack doesn't hear anything (lacp bpdus) from the other side to put the ports in individual state which apparently is not the case.

kind regards.

-- Juan