Netgear ReadyNas New User - Setup issues

[Vapebear]

Hi,

I have recently purchased 2nd hand a Netgear READYNas Duo 2 and been able to:

• Install Drives
• Reset the system
• Updated the Firmware to 5.3.13

If I try to access via AdminUsing Netgear Radar to access the Admin Page

But I still cannot access the drive via my Web Browser (Yes allowed the Security Certificate and get the following screen whenever I try to get into the Admin Rights:

Does anyone know if I should be updating the BIOS Software further? Or has this device really come to total "End of Life"?

Any suggestions would be welcome!

[eton · Accepted solution]

To bypass the error message `SSL_ERROR_UNSUPPORTED_VERSION`, do this in Firefox:

1. Open the address: about:config
2. Change security.tls.version.min to 1.
3. Reload the page with the error message or open the address {NAS IP}/admin

I don't know how to do this i Chrome.

(Your attached attached images are not visible.)

[eton · Accepted solution]

To bypass the error message `SSL_ERROR_UNSUPPORTED_VERSION`, do this in Firefox:

1. Open the address: about:config
2. Change security.tls.version.min to 1.
3. Reload the page with the error message or open the address {NAS IP}/admin

I don't know how to do this i Chrome.

(Your attached attached images are not visible.)

[StephenB]

---

@eton wrote:

I don't know how to do this i Chrome.

---

You can't.  But both Internet Explorer and Edge in IE mode will work. More info is in this thead:

• https://community.netgear.com/t5/New-ReadyNAS-Users-General/Workaround-for-ERR-SSL-VERSION-OR-CIPHER...

@Vapebear once you regain access, you can install this add-on:

• https://github.com/rdynsxtrs/r5bin/blob/master/apache2/Apache2_2.2.34-arm-0.0.1.bin

That will install TLS 1.2 on your NAS, so you won't need to continue with FireFox.

[Vapebear]

Thank you for the solution - I have now been able to access the drive and start the set up process 🙂

[eton]

Glad it worked.

You can also have a look at the other solution where you install an add-on.

Now I can see your attached images. Maybe the forum needed some time to process them.

[StephenB]

---

@eton wrote:

Now I can see your attached images. Maybe the forum needed some time to process them.

---

FYI, all embedded images need to be reviewed/approved by a mod before they are seen.  That can take a while (depending on how busy the mods are).