Wifi Mesh 6 connects to internet but will not broadcast to connected devices.

[vanrina]

We recently had a power outage and upon performing a factory reset and implementing the previous settings I had prior to power outage, I can not longer connect to internet via WiFi connection.  I have verified that the modem is still pushing internet with a direct connection, however when I plug into the base station of my Nighthawk Mesh and attempt to connect to the internet, it connects but without internet.  I have also attempted to change my WiFi broadcast settings to something different than what I had before and I get the same results.  Could the power outage corrupt my mesh system?

[FURRYe38]

What Firmware version is currently loaded?
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?
Be sure your using a good quality LAN cable between the modem and router. CAT6 is recommended. 

Has a power off for 1 minute then back ON with the ISP modem and router been performed since last update?
Be sure to restart your network in this sequence:
Turn off and unplug modem.
Turn off router and computers.
Plug in and turn on modem. Wait 2 minutes for it to connect.
Turn on the router and wait 2 minutes for it to connect.
Turn on computers and rest of network.

Has a factory reset and setup from scratch been performed since last FW update? A complete pull of the power adapters for a period of time after the factory reset then walk thru the setup wizard and setup from scratch with a wired PC and web browser. Recommend setting the default DHCP IP address pool range to the following after applying and a factory reset: 192.168.#.100 to 192.168.#.200.
https://kb.netgear.com/24089/How-do-I-specify-the-pool-of-IP-addresses-assigned-by-my-Nighthawk-rout...