Orbi Locks Print servers when it Reboot

[JSnJSoftware]

everytime any of the orbis restart, this happensI purchased 2 orbi RBR53

when it restarts, the signal is sends out LOCKS the 5 print servers that I have running.

It is attached to netgear switch that get LOCKED when the Print Servers get locked

after I power off and back on the Print Servers, the NetGear switch and the printers attached start working again

everytime any of the orbis restart, this happens

[michaelkenward]

I'm afraid I don't understand the problem, but I do know that there is a better place to ask about Orbi kit.

You might get better and quicker replies, and find other answers, over in the appropriate section:

Orbi - NETGEAR Communities

[schumaku]

What kind of print servers - make, model, firmware, ...?

Any kind of however manageable Netgear switch supporting STP, and with STP enabled?

And last but not least - why _two_ RBR53 - for the same network?

[FURRYe38]

Try setting a static IP address ON your print server devices out side the routers DHCP IP adress pool You may need to change the RBRs IP address pool from 192.168.1.2 thru .254 to 192.168.1.100 thru.200. This leaves room for static IP addressed devices on either side of the pool.