RBK23 upload speeds in Router mode

[DeividN1]

Hi there, 

Why Netgear mesh systems (like my RBK23) limits dramatically the upload speeds setting up as Router? if I use the system as AP, all works perfect, but in Router mode... I can't obtain speeds over 250Mbps in a 600/600 line. I have try all but I cant solve it. I have the last firmware.

Anybody with the same problem?...

Thanks in advance.

[plemans]

Make sure qos, traffic monitoring, parental controls, and access controls are disabled and reboot the router. those can sometimes decrease speeds. 

[DeividN1]

Thx for your reply, all this services are disabled, but how can I check if QoS is off? I've read in some site that QoS is default off, it's true?

[plemans]

What modem/gateway is it connected to? are you running in a double nat? 

https://kb.netgear.com/30186/What-is-Double-NAT

[DeividN1]

The ISP modem, is a HGU from Movistar/O2, the typical Mitrastar mounted by this corp like this one:

The modem is in bridge mode and all weight of network is over the Orbi RBR, I have single NAT.

[plemans]

Photos have to be approved by a moderator. 

And it wouldn't be the first time an ISP supplied device didn't have a properly functioning bridge mode/passthrough mode. 

[DeividN1]

Oh, sorry, I didnt konw.

It would be, but I've see this router (and same ISP) bridged working well with another systems.

Anyway, it's very strange, because when I setup the system for first time, I have the complete bandwith, but If I reboot the router, in this moment I start to have slow up speeds... And allways with a specific speed, without fluctuations.

[DeividN1]

I've check qos, and it's disabled, but my upspeed results stiill bad as can see in the picture.

[plemans]

Did you try it with the moviestar in router mode and the netgear in access point mode?

[DeividN1]

Yes, I have had it in AP mode and works fine. I’ve search info about this problem, and I find something very interesting... Movistar can’t warranty speeds over ppoe in bridged mode, and I think that the problem is the HGU router. I’ve bought an neutral ONT Ubiquiti for remove HGU. I will receive it tomorrow, when I test it, I will report the results here. Thanks!!!