RBR853 - Disable NAT and Routing, but keep Mesh?

[packet_gnome]

Hello all.

I have an RBR853 mesh set up at home.  Works well.

I am looking to place the RBR853 mesh network behind a firewall, which will be doing NAT and routing outound (towards Internet - multiple uplinks) and inbound (looking to break out multiple VLANs via a switch to segent the inside home network).

In this scerario, I would prefer to eliminate the layer of NAT, routing, and DHCP service provided by the RBR853 base, and have these services provided by the firewall instead.  I am aware that I can turn the Orbi system into AP-only mode, which would do this - BUT my question is, if I switch the Orbi system to AP-only mode, do I lose the mesh capability of the Orbi system?

Dave

[FURRYe38]

Please post about this over in the Orbi AX forum:
https://community.netgear.com/t5/Orbi-AX/bd-p/en-home-orbi-ax

Configure AP mode on the Orbi router. https://kb.netgear.com/31218/How-do-I-configure-my-Orbi-router-to-act-as-an-access-point and https://www.youtube.com/watch?v=H7LOcJ8GdDo&app=desktop

Thank you.

[FURRYe38]

And No. 

[CrimpOn]

---

@packet_gnome wrote:

my question is, if I switch the Orbi system to AP-only mode, do I lose the mesh capability of the Orbi system?

---

No.  Orbi remains a "mesh" for WiFi devices connected to the Orbi.