Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
GS748T need to power cycle, yet I cannot see it on the network
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2021-09-24
07:04 AM
2021-09-24
07:04 AM
GS748T need to power cycle, yet I cannot see it on the network
some ports are not functioning and I probobly need to power cycle. I also cannot see the switch from the network. (I use the netgear discovery tool and an IP range scanner). can I just pull the plug for power cycling or do I need to do more?
Model: GS748Tv4|Netgear 48 ports Smart Switch
Message 1 of 2
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2021-09-24
12:37 PM
2021-09-24
12:37 PM
Re: GS748T need to power cycle, yet I cannot see it on the network
Welcome to our community! 🙂
You can just unplug it from the power outlet or press the reset button for 5 secs and see if the switch will reboot. If it is still not working, you can try to do hard reset by pressing and holding the reset button for 30 seconds or if there is a factory default button.
Regards,
John
NETGEAR Community Team
Message 2 of 2