Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: VLAN ID limitation?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2020-06-26
12:11 PM
2020-06-26
12:11 PM
I'm configiring this switch for my network and the existing VLAN i need to connect it to is 100 . In the configuration,
VLAN -> Port Based -> Advanced -> VLAN Identifier .
The VLAN ID goes up to 24. Is there a way to configure the swicth to use a VLAN higher than 24 ?
Solved! Go to Solution.
Model: JGS524Ev2|ProSafe Plus 24 ports gigabits switch
Message 1 of 5
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2020-06-26
01:02 PM
2020-06-26
01:02 PM
For fully flexible 802.1q VLAN config use VLAN -> 802.1Q -> Advanced etc.
Message 2 of 5
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2020-06-26
01:02 PM
2020-06-26
01:02 PM
For fully flexible 802.1q VLAN config use VLAN -> 802.1Q -> Advanced etc.
Message 2 of 5
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2020-06-27
06:21 AM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2020-06-27
06:26 AM
2020-06-27
06:26 AM
Re: VLAN ID limitation?
Be careful using only the very same entry - using another VLAN "mode" by accident will erase the config in place for another VLAN mode.
Message 4 of 5
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2020-06-27
06:37 AM