Select your NETGEAR Community

Hi, i have used this extender for a number of years now, but something that has always bugged me has finally reached the end of my patience: when i am in an area of the house where my modem router do...

Hi I have a new device I need to connect to the network that requires my phone to be connected to a 2.4GHz wifi. As my phone will not allow me to select the frequency, I need to make a change to the...

The reset button has been held for 10+ seconds and the web page for the ipaddress times out. MNU_access_setRecovery_index.htm  

I have expired vpn certificates on my router WNDR3700v5 Not Before: May 9 10:27:47 2014 GMT Not After : May 6 10:27:47 2024 GMT Already installed the latest firmware for this router which is&...

Hi, I apologise if this is a topic that has been asked before, I cannot find it, if so. I have a Mesh WiFi setup, an RBR20 router, with two RBS20 satellite units. I have connected a small (8-port...

I updated my 854 system Saturday. Using the manual FW update method: https://community.netgear.com/t5/Orbi-WIFI-6-AX-AND-Wi-Fi-6E-AXE/Procedure-for-Factory-reset-of-RBS850/m-p/2359585/highlight/tru...

(Updated) I initially thought "Bad luck" as I started by upgrading one of the thee satellites (an RBS850) ....and it was impossible to reconnect it to the the RBR. It keeps blinking white when boo...

Other satellites and then router went OK: everything is now up and running. Note that the administration console of the router has a popup warning discouraging to do manual firmware upgrade ....al...

Had anyone updated to this new version yet? Does everything work correctly?

RBR connected to a CM3000 cable ISP modem. 1Gb WAN Port on CM Modem. ISP - Sparklight 1Gb/50Mbps ISP Speed plan.  Armor, SPC and Traffic Meter not enabled.  RBR Onboard Speed T...