Select your NETGEAR Community

I have a pair of NETGEAR GS110EMX switches, one connected via port 10 to the 2.5Gbps port of an Orbi RBRE960 router, and the second connected "back to back" to the first switch through their 10G...

I have seen similar threads to my issue in this forum, but none that indicate a successful resolution:   I recently purchased an Orbi 7 system; unfortunately a couple of my more important WiFi...

Bought this ReadyNAS. This serial number is already registered to another customer. Please email NETGEAR support Customer.service@netgear.com for help.   I've emailed support, is the...

Hi everyone,   Occasionally, we need to connect our m4250 to other private networks. We've allocated 2 ports for this, designated as external VLAN 80.   Could someone advise on how to g...

I got the Nighthawk Router (RAXE300) today and spent several hours trying to set it up. I have a Cisco router provided by Spectrum, and my old router is a Belkin router. Whenever the modem is connect...

Something I did find with Auto Update and distances with RBS and some units not updating while others did. If the RBS do not have a good signal from the RBR when wirelessly connected, then there is a...

Are the RBS750s on the same system as the 852 or are they on a separate system? FYI, the 750 series FW was just put up early this morning. So the RBS750 may have not seen anything until today or la...

Select here:   Ok, Should be ok, however would be good to be all on same FW version since there both now at v.31. Update when you can.    Enjoy. 

Are the RBS750s on the same system as the 852 or are they on a separate system? FYI, the 750 series FW was just put up early this morning. So the RBS750 may have not seen anything until today or lat...

I finally manually updated to V7.2.6.21 a few weeks ago since it never showed up in the firmware update interface. Now I’m not seeing V7.2.6.31, I’ll give it a few days before updating manually.