Select your NETGEAR Community

my nighthawk CM2000 modem , looks to have the power led and the globe internet led burnt out can they be replaced. Everything seem to be working ok. the upstream and downstream led ar lit as is the m...

This is a multi-part question so bear with me while I explain this bizarre behavior, which isn't always the same exact bizarre behavior each time which makes it very difficult to figure out the cause...

New installation of a G316EP with a single WAX615 AP attached. Router is an AT&T BGW320-500. WiFi is turned off on the router. DHCP is being handled by the router with a range of 192.168.1.1 – 25...

need help to connect for the first time   

Hi, i have used this extender for a number of years now, but something that has always bugged me has finally reached the end of my patience: when i am in an area of the house where my modem router do...

I updated my 854 system Saturday. Using the manual FW update method: https://community.netgear.com/t5/Orbi-WIFI-6-AX-AND-Wi-Fi-6E-AXE/Procedure-for-Factory-reset-of-RBS850/m-p/2359585/highlight/tru...

(Updated) I initially thought "Bad luck" as I started by upgrading one of the thee satellites (an RBS850) ....and it was impossible to reconnect it to the the RBR. It keeps blinking white when boo...

Other satellites and then router went OK: everything is now up and running. Note that the administration console of the router has a popup warning discouraging to do manual firmware upgrade ....al...

Had anyone updated to this new version yet? Does everything work correctly?

RBR connected to a CM3000 cable ISP modem. 1Gb WAN Port on CM Modem. ISP - Sparklight 1Gb/50Mbps ISP Speed plan.  Armor, SPC and Traffic Meter not enabled.  RBR Onboard Speed T...