Select your NETGEAR Community

I am planning to built a WiFi network inside a multi-storey metallic structure.  There are totally 5 floors.  Area of each floor is around 350m sq with rooms separated by metallic partition...

Got a new modem/router from Breezeline. I reset the WiFi extender to factory setting, paired it with router.  It indicates network is available and has all green solid lights. When I enter passw...

RBK843S (RBR840, RBS840) all running v4.6.14.5.  I noticed that the router shows 2.4ghz wireless mode "up to 1147 Mbps" but both satellites show 2.4ghz wireless mode "up to 574 Mbps" (both route...

I've been struggling with the last couple firmware releases, up to 9.11.1.1.  Every 4 days like clockwork, the router would go down and take my whole network with it.  It wouldn't restart.&...

Hi, Looking for help from netgear support. I’m trying to use anywhere access on my LBR20 and it says “this device is already registered” with an email that’s not mine. Thanks    

(Updated) I initially thought "Bad luck" as I started by upgrading one of the thee satellites (an RBS850) ....and it was impossible to reconnect it to the the RBR. It keeps blinking white when boo...

I updated my 854 system Saturday. Using the manual FW update method: https://community.netgear.com/t5/Orbi-WIFI-6-AX-AND-Wi-Fi-6E-AXE/Procedure-for-Factory-reset-of-RBS850/m-p/2359585/highlight/tru...

Other satellites and then router went OK: everything is now up and running. Note that the administration console of the router has a popup warning discouraging to do manual firmware upgrade ....al...

Had anyone updated to this new version yet? Does everything work correctly?

My RBR850 and RBS850 auto updated and so far all is working w/o issue.