NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
M4350-12X12F SNMP v3 traps configuration
How to configure SNMP v3 Traps on this switch? I have current snmp config: snmp-server sysname "CENSORED-SYSNAME" ! snmp-server user "zabbix-netgear" DefaultWrite auth-sha512-key CENSORED-AUTHKEY priv-aes128-key CENSORED-ENCKEY snmp-server password-strength snmp-server v3-host CENSORED-IP "zabbix-netgear" traps priv acl-trapflags snmp-server enable traps captive-portal snmp-server enable traps mac-notification change ip dvmrp trapflags ip pim-trapflags However snmptrapd says that this user has authentication failure, here is part of the config createUser -e SWITCH_ENGINE_ID zabbix-netgear SHA "CENSORED-AUTHKEY" AES "CENSORED-ENCKEY" Despite having correct engine ID, correct keys switch cannot properly authenticate? I think problem lays in switch itself because sending test trap using snmptrap with same engine ID, auth key and encryption key works fine. Firmware 14.0.4.14GS724T - Which HW & FW version?
I "inherited" a GS724T. I have no real idea how old it is, nor which HW version it is. It is currently running v1.2.3 FW. There is no obvious serial number, only a single label with it's MAC address. How do I determine the specfic HW version? Which version of the FW can I install on this unit? Specifically, I'm looking for SNMP support which is apparently not included in v1.2.3. Thanks. T.