7328sv2 firmware, changes 8 to 10?

I had some other model that need increments. I would read any notes attach to the file or have instruction on the products support page.

I would normally do the last v8, then the v10, but my point really is that there is nothing relevant in the notes or on the support page. If there is please post a link.

If not listed then ask support directly on confirm answer

Usually it will not load if don't like it. Happened on my switch in the past

Don't take my word but looks like there is no incremental

There is no documentation for v10 available at all that I can find. Please correct/direct me.

A short script that I used before now gives me an error "An invalid interface range has been used for this function. An interface range must be 1000 characters or less." as soon as I type "interface range "

Looks like I'll be booting back in to v8 tonight.

If not listed then ask support directly on confirm answer

netgipg wrote:
There is no documentation for v10 available at all that I can find. Please correct/direct me. A short script that I used before now gives me an error "An invalid interface range has been used for this function. An interface range must be 1000 characters or less." as soon as I type "interface range " Looks like I'll be booting back in to v8 tonight.

You the v10 CLI guide from following link:
http://www.downloads.netgear.com/files/GDC/M5300/M5300%20CLI%2027Nov2012.pdf

As for the range, modify your script since the new firmware 10.0.0.x follow M5300 CLI changes

instead of

interface range 1/0/1-1/0/20

Now you can do

interface 1/0/1-1/0/20,1/0/24,1/0/28-1/0/30

I hope that helps.