M4300-24X Routing guide

Question

Hi Sir,&nbsp;I would like to deploy OSPF &amp; RIP protocol using M4300-24X.&nbsp;May I know if do you have an example scenario of document to refer to?&nbsp;Thanks.C.

Retired_Member · Answer

Hi Carva,  Welcome to the community!
 For dynamic routing protocol(RIP&amp;OSPF) admin guide, please refer to M4300 Software Administratrion Manual. Click the&nbsp;Link and go to Chapter 6(RIP) and Chapter 7(OSPF) for typical scenario&nbsp;configuration. Hope it helps!  Regards,  EricZ NETGEAR employee

Retired_Member · Answer

Hi&nbsp;Carva,
&nbsp;
I just want to follow-up on this. Does this suggestion resolve your problem?
With regard to resolve your problem, I encourage you to mark the appropriate reply as the “Accepted Solution” so others can be confident in benefiting from the solution. The NETGEAR Community looks forward to hearing from you and being a helpful resource in the future!

Carva · Answer

Hi Eric,&nbsp;Thanks for the quick response and support.May I know if do you have some example scenario that I could refer to?&nbsp;The guide that you provide is good, but I still don't know how to implement it in a real network environment.&nbsp;Thanks.C.

Retired_Member · Answer

Carva,
&nbsp;
Actually, the link above is typical network topo and confuguraiton for RIP and OSPF.

If you want to deploy RIP or OSPF in your real network and need some further more support, I suggest you provide your network topo and design requirement. According the detailed requirement, We can give&nbsp;you detailed suggestion.

Forum Discussion

M4300-24X Routing guide

4 Replies

Related Content

M4300-24x: spontaneous reboots dispite latest firmware

M4300-12X12F replacing M7100-24X - Wireless Access Points not working

M4300-24x

M4300-24x: switching ports to "stack" mode needs reboot?

M4300 24X: sudden restarts

NETGEAR Academy

ProSupport for Business