NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
M4300 Inter-VLAN routing
Hi there, I've been trying to setup a M4300-8X8F with inter-vlan routing for hours now to no avail. I'm running the latest firmware (12.0.4.8) and have followed all the instructions found in the U...
I can't see the picture (it takes a while for the moderators to approve it for display).
It's kinda hard to tell where the IP addresses are assigned. I'm guessing that 192.168.50.254 is assigned to the M4300? If yes, then are the static routes for the VLAN subnets pointing to 192.168.50.254?
I can't see the picture (it takes a while for the moderators to approve it for display).
It's kinda hard to tell where the IP addresses are assigned. I'm guessing that 192.168.50.254 is assigned to the M4300? If yes, then are the static routes for the VLAN subnets pointing to 192.168.50.254?
Hi logicallysynced,
Welcome to the community!
Could you please do more test as below for further analysis:1. From Firewall, check if ping 10.0.10.254/192.168.10.254 success?
2. Run CLI command 'show ip interface brief' on switch
3. Run CLI command 'show ip route' on switch
4. It's better if you can provide the tech-support file of the switch
How do I send tech-support files from my Managed Switch to NETGEAR community moderators?
http://kb.netgear.com/app/answers/detail/a_id/31439
Hope it helps!
Regards,
EricZ
NETGEAR employeeAh this was the problem, the default gateway was set to the VLAN SVI and not the gateway VLAN's SVI. Thanks so much!!
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
