Security Camera Instl on Private Lan using SightHound DVR Software - How do i setup dhcp server

Thank you John,  

I will try the link.  Is the following correct?

I've set the switch (System/Management/IPv4 Management VLAN Configuration) to the following: (note, i've reused vlan id 1, don't know if i should have.)

VLAN ID: 1

Routing Mode: Enable

Configuration Method: Manual

IP Address: 172.16.1.254

Subnet Mask: 255.255.254.0

Default Router IPv4: 172.16.0.1

(should give me an ip range of 172.16.0.1 - 172.16.1.254; I'm thinking this is what the dhcp server will use.)

The network interface on the Computer/DVR:

IP address: 172.16.0.2

Subnet mask: 255.240.0.0

Default gateway: 172.16.0.1

I've also setup a ntp server on the computer and set the switch to use it, and that works.

#show running-config

!Current Configuration:
!
!System Description "M4100-24G-POE+ ProSafe 24-port Gigabit L2+ Managed Switch with PoE+, 10.0.2.26, B1.0.1.1"
!System Software Version "10.0.2.26"
!System Up Time          "0 days 1 hrs 58 mins 44 secs"
!Additional Packages     QOS,IPv6 Management,Routing
!Current SNTP Synchronized Time: Jul  6 21:48:25 2017 UTC
!
hostname "CameraNetwork"
vlan database
vlan routing 1 1
exit

configure
sntp server "172.16.0.2"
time-range
ip name server 172.16.0.1
ip default-gateway 172.16.0.1
line console
exit

line telnet

exit

line ssh
exit

snmp-server sysname "CameraNetwork"
snmp-server location "MB Closet"
snmp-server contact "Eric Anderson"
!

interface 0/5
bandwidth 100000
routing
ip mtu 1500
exit

interface vlan 1
routing
ip address 172.16.1.254 255.255.254.0
exit

service dhcp
exit