VLAN Configuration in CLI on Netgear M4100-26G

I bought a M4100 Second hand and I want to configure some Access and Trunk ports on it. I come from the Cisco line of Switches from work so I know how to configure them there. But The Netgear CLI seems very different and unintuitive for me.

How would I go about configuring an Acessport onto a range of interfaces?

I have seen you can select several interfaces just with the interface command, and how woudl I then configure them?
With Acessports for VLANs, I want them to Filter ingress traffic for untagged only, the same for egress, but where do I actually tell the Interface which VLAN to tagg the incomming packets with inside the switch?

For trunkports I probably want to filter for tagged only traffic for ingress and egress but also here I am not sure where to configure the allowed vlans?

Any help would be appriciated.