NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.

Forum Discussion

ProjectEdu's avatar
ProjectEdu
Aspirant
Feb 15, 2022
Solved

Whitelist MAC-Addresses on GS724T

Hello,

 

how should I configure the GS724Tv4 Switch, to just allow certain devices the communication?

I need this for a school project, my idea was to just allow certain Mac-Addresses, so devices that just connect to the switch arent able to communicate with other devices connected to the switch. 

Is there a option to whitelist certain MAC-Addresses? I tried a few methods I found while researching but they didnt work out as expected.

 

  • Hi ProjectEdu,

     

    Yes, you're right. You could whitelist certain MAC addresses on a particular port and limit it to a certain number depending on your preference but it'll take a while to configure it.

     

    An easier way is to use MAC ACL (not sure if you tried this as well) which is used to permit or deny access to the network, please check this guide on how to configure it.

     

    As for the devices that should not communicate with each other even though they're connected to the same switch, you'll need to configure a VLAN (you may refer here in this KB article).

     

     

    Regards, 

     

    JeraldM

    NETGEAR Community Team

4 Replies

  • JeraldM's avatar
    JeraldM
    NETGEAR Employee Retired

    ProjectEdu,

     

    Welcome to the community! 

     

    You could use Port Security in this case. Please refer to page 203 of the user manual here for more information.

     


    Regards, 

     

    JeraldM

    NETGEAR Community Team

    • ProjectEdu's avatar
      ProjectEdu
      Aspirant

      Hi, thank for the response!

      But how should I configure that, as far as I understood Port Security is for limiting MACs learned by the Ports.

    • JeraldM's avatar
      JeraldM
      NETGEAR Employee Retired

      Hi ProjectEdu,

       

      Yes, you're right. You could whitelist certain MAC addresses on a particular port and limit it to a certain number depending on your preference but it'll take a while to configure it.

       

      An easier way is to use MAC ACL (not sure if you tried this as well) which is used to permit or deny access to the network, please check this guide on how to configure it.

       

      As for the devices that should not communicate with each other even though they're connected to the same switch, you'll need to configure a VLAN (you may refer here in this KB article).

       

       

      Regards, 

       

      JeraldM

      NETGEAR Community Team

      • ProjectEdu's avatar
        ProjectEdu
        Aspirant

        Hello, JeraldM 

         

        ACL Filter worked, just had to put in the MAC Mask as well as the MAC-Addressa and then it worked perfectly fine. Thank you :)

NETGEAR Academy

Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology! 

Join Us!

ProSupport for Business

Comprehensive support plans for maximum network uptime and business peace of mind.

 

Learn More