NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
can not change LAG Type to LACP . XS748T ProSAFE 48-Port 10-Gigabit Smart Managed Switch
Hello
I set up LAG7 with ports 7 & 8 as members.
yet at LAG Configuration i can not change LAG Type from Static to LACP.
this error displays: "LAG type cannot be changed for LAGs with no port members".
How can I set the LAG type to LACP?
Note there are not any wires attached to ports 7 and 8 yet...
Hi robfantini,
Welcome to the community! :)
Your concern is similar to the forum thread below. Kindly access, read and follow the suggestions posted in it.
Regards,
DaneA
NETGEAR Community Team
3 Replies
Replies have been turned off for this discussion
Hi robfantini,
Welcome to the community! :)
Your concern is similar to the forum thread below. Kindly access, read and follow the suggestions posted in it.
Regards,
DaneA
NETGEAR Community Team
OK I'll try that an it'll probably work.
also this is a bug. you know that right?
since 10 other models do not require this work around.
I know you probably do not do the switch low lebvel programming. However others will run in to this - and it should be fixed with a firmware upgrade sometime .
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
