NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.

Forum Discussion

mparikh's avatar
mparikh
Aspirant
Jun 23, 2017
Solved

Netgear ProSafe JGS524Ev2 - IP/MAC Address Table

Hello Everyone,

 

Model: JGS524Ev2

Firmware:  2.0.1.40

Utility: ver 2.4.3

OS: Windows 7

 

My name is Meet Parikh and I'm an Electrical Engineering at CTDI in West Chester PA. Now I just joined the company after graduating from Penn State and have been on the job for about a week. My manager has given me a project that was on standstill as the guy working on it transfered to another division and it's my job to finish it. My manager gave me the ProSAFE JGS524E v2 Switch and told me to use either SNMP or SSH protocols to communicate with properitary software that CTDI uses and in addition to that pull the IP/MAC address table from the switch. I researched online but I couldn't find how to do so with this switch. So Is there a way to 

  • Use Utility/Web Management to get IP/MAC Address Table?
  • Remotely (through SNMP, SSH, Telnet, etc....) get the IP Address of the device connected on a specific port of the switch?
  • Remotely (through SNMP, SSH, Telnet, etc....) control (enable/disable) a specific port on the switch

Thank you,

 

Meet Parikh

  • Hi Mparikh

     

    The Switches that support VLAN, Telnet, SNMP,SSH,CLI are our Fully Managed switches , see below a a link with all our fully managed families:

     

    https://www.netgear.com/business/products/switches/managed/

     

    About the IP/MAC/Port Address you will have to combine a sh arp and sh mac-addr-table to be able to get the IP/MAC/Port

     

    Regards

     

    Xavier Lleixa

    NETGEAR CBU PLM

4 Replies

  • XavierLL's avatar
    XavierLL
    NETGEAR Employee Retired

    Hi mparikh

     

    Welcome to our community!

     

    Unfortunately the JGS524E doesn't support SSH/SNMP or CLI so in this case you will not be able to get the MAC address table from the switch.

     

    I would suggest to use our M4100 switch series where we support SSH and SNMP and you can send commands to get the MAC address table

     

    https://www.netgear.com/business/products/switches/managed/M4100-26G.aspx#tab-techspecs

     

    Hope it helps!

     

    Xavier Lleixa

    NETGEAR CBU PLM

    • mparikh's avatar
      mparikh
      Aspirant

      Does JGS524Ev2 have VLAN capabilities, or what switch would you recommend for both telnet/SNMP/SSH and VLAN capabilities.

       

      Thank You,

       

      Meet Parikh

      • mparikh's avatar
        mparikh
        Aspirant

        I meant to ask you the following question in the previous reply post:

         

        What switches does Netgear have with VLAN capability in addition to remote control (Telnet, SNMP, SSH, CLI) to enable/disable ports and get IP Address of devices connected to the ports?

         

        Thank You,

         

        Meet Parikh

NETGEAR Academy

Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology! 

Join Us!

ProSupport for Business

Comprehensive support plans for maximum network uptime and business peace of mind.

 

Learn More