Forum Discussion
port forwarding doesnt work with PR60X router and M4300-48X switch
I am unable to get the public IP to forward to an internal IP. I've setup port forwarding many times, but I can't get it working on this equipment. I'm using a PR60X router and a M4300-48X switch. ...
Haven't seen -any- NAT config on these "dual-WAN port router".
No controls for two WAN interfaces, no port forwarding for each of these .... just what the product management thought is essential. Port forwarding does very likely work on the WAN1 only.
Based on the data sheet and the user manual - there is not much - I would -never- consider an evaluation or even buy one. And no, despite having asked several times: Netgear preferred -not- to provide a test unit.
Appears they had a very limited, simple use case (if anything) in mind.
At the risk this will be my last post here: That's all I can and will say here.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
