WC7520 and WNDAP360 problem with one AP after IP changed

Hi,

Alternatively you can follow the procedure below: 

1. Hard reset the AP by pressing Reset button more than 10seconds
2. Afer the hard reset, AP will get assigned to default IP 192.168.0.160
3. Login to AP using default ip i.e 192.168.0.160 (by configuring laptop with static ip 192.168.0.xx) 

   username "admin" and password is "password"

4. Once you login to AP Modify below changes 

        Go to Configuration --> IP -> DHCP Client --> Disable

         i) Please enter the following details as per your network

            IP Address  --> 

            IP Subnet Mask -->

            Default Gateway -->

          Apply the changes

         ii).Go to Controller Settings

            Controller IP -->Update your controller ip

            Apply the changes and reboot the AP.

      5. Go to Controller--> Access point --> Discovery Wizard--> Select "Factory Default state" Press on "Next" tab --> Select second option "Different L3 Networks" --> Specify ip range and then press Next button 
      6. Discovery wizard will discover the WNDAP360 AP from the network, once the discovery is done you can add it to WC7520 Controller