NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
Re: DHCP constantly renewing XR500
Hi all,
I also started getting the same dhcp lease renewal issue. Im using version 134. I have been using it for years but the past few weeks the router started having this issue.
I tried setting up the max dhcp value to 100 and also reserved ips for my devices. It worked for a week and started again.
Please help
I also started getting the same dhcp lease renewal issue. Im using version 134. I have been using it for years but the past few weeks the router started having this issue.
I tried setting up the max dhcp value to 100 and also reserved ips for my devices. It worked for a week and started again.
Please help
- Hi Fraser,
Yes i did that and the router seem to be working fine for now. I flashed version 114 using tftp, did factory rest and then upgraded to 134.
Thanks for the usual support.
MJ
10 Replies
Try setting DHCP range from .100 to .200?
Has a power off for 1 minute then back ON with the ISP modem and router been performed since last update?
Be sure to restart your network in this sequence:
Turn off and unplug modem.
Turn off router and computers.
Plug in and turn on modem. Wait 2 minutes for it to connect.
Turn on the router and wait 2 minutes for it to connect.
Turn on computers and rest of network.Has a factory reset and setup from scratch been performed since last FW update?
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?
- Hi,
I tried the suggested solution, but the issue persists. The router stayed fine for a couple of days though
My modem is huawei hg8245w5.
I dont remember if i have done mf reset on the firmware.
Any tips ?- Disable DHCP entirely (make sure you've reserved all the IPs) and then it should be better
- Did you set the reserved IPs outside the range you set?
