NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
CAX30 - 2.4 wifi bad /5ghz good?
Not sure what's going on but all of a sudden the router won't allow connection via wifi 2.4 but does connect on 5 ghz.
Reset the router to factory specs - I'm using xfinity service
On several devices (phones, computers) - I told the devices to forget the 2.4 connection - upon refresh the 2.4 connection doesn't show anymore but the 5 Ghz is available and allows connection. Unfortunately my Ring Security system works only on 2.4 ghz among other older devices I have and without a 2.4 connection leaves many devices useless.
I went to total reset to factory specs to make sure no other settings were interfering with the 2.4 radio. Upon restart and even though the 2.4.light on the modem is flickering as it normally does there was no mention of my 2.4 connection on any of my devices - only the 5ghz showed and allowed connections.
Running Firmware Version V2.2.4.2 The modem/router has been working properly for months using this firmware. I would think that reverting to an earlier firmware wouldn't change things since a factory reset didn't change anything.
Thoughts?
1 Reply
One "box to check":
2.4G WiFi is limited to channels 1-11 in some countries, with 12 & 13 available in others. If the router has changed to channel 12 or 13 because "look. there's nobody using this one!", then devices searching on channels 1-11 will no longer detect the signal.
