NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
WG602 v3...Cannot get into config utility!???
Hi all...Can someone please tell me as to how I can get into the wireless settings. I guess I mean the IP address for the AP. It's supposed to be 192.160.0.1, or 192.168.1.1, correct?
Well, I have a router from AVM, and I'm able to get into ITS config utility when I'm not even connected to it directly, but not with the Netgear AP. I even connected it with an Ethernet cable, and nothing on either IP.
Please help! :(
Thanks!
7 Replies
CrunchDude wrote: Hi all...Can someone please tell me as to how It's supposed to be 192.160.0.1, or 192.168.1.1, correct?
I doubt it. From memory the default IP address as shipped from the factory is 192.168.0.227.
Maybe you should do a "factory" reset, connect your computer by ethernet, and do your set-up from the beginning.
The user maunual is linked from here
http://kbserver.netgear.com/products/WG602v3.aspaechmea wrote: I doubt it. From memory the default IP address as shipped from the factory is 192.168.0.227.
Maybe you should do a "factory" reset, connect your computer by ethernet, and do your set-up from the beginning.
The user maunual is linked from here
http://kbserver.netgear.com/products/WG602v3.asp
Oh that's right, and I also tried 192.168.0.227. Multiple times. I CANNOT get into the darn router. What could be the cause? I'm asking because I NEVER could configure it to anything ever!! :(
Thank you everyone!- Did you try to factory reset your WG602v3?
After that, you should be able to open config page by surfing to http://192.168.0.227
For me, getting the unit to do a factory reset was somewhat tricky, so I wrote down the steps for this here: click! - Oh thank you, sir! ;) I can't believe that everything with that darn AP is so difficult and complicated. ????
Thanks!! - Oh thank you, sir! ;) I can't believe that everything with that darn AP is so difficult and complicated. ????
Thanks!! - I am having the same problem, and I have reset the AP several times (holding down the button for more than 10 secs), have followed the directions to a T, and it still only get "IE can't display the webpage" error instead of the login box. I had this on a network, and it worked great. Then I changed routers and network names and just wanted to update it - couldn't log in to the AP. Nothing works, IP or MAC login.
Please help!!! jedijurist wrote: I am having the same problem, and I have reset the AP several times (holding down the button for more than 10 secs), have followed the directions to a T, and it still only get "IE can't display the webpage" error instead of the login box. I had this on a network, and it worked great. Then I changed routers and network names and just wanted to update it - couldn't log in to the AP. Nothing works, IP or MAC login.
Please help!!!
Never mind - I finally got it to work by AGAIN changing the static IP addresses. Funny thing, they were already on the correct settings, but I just applied them again and, magically, it worked on the second time around.
