When I power on the device, the Power led goes green for about 5 seconds, goes off and then the USB led stays lit even though nothing is plugged in.I have found that if I hold the Reset button while the device is powering up, I can get the Power led to stay lit. The problem is, the Wifi and WPS leds alternate flashing constantly when in this mode. Any ideas?

Here is the link for reflashing the router https://kb.netgear.com/22688/How-to-upload-firmware-to-a-NETGEAR-router-using-TFTP

R6220 Stuck in USB | NETGEAR Communities

William10a
Master
Mar 21, 2017
Sounds like the router is not booting up and may be bad frimware or possible hardware would go the frimware as my best bet.
Have you reset the router by chance?
- anthonystubb
  Aspirant
  Mar 21, 2017
  Since no wifi is being brodcast, I cannot update the firmware through any means that I'm aware of.
  Yes, I have tried to reset the router using multiple methods including the Reset button and Power button.
  - William10a
    Master
    Mar 21, 2017
    Do you have a laptop or desk top computer with a wired lan port you could connect a lan cable between the router on a free lan port the the lan on the computer to access the router if the lan ports are working.
anthonystubb
Aspirant
Mar 21, 2017
Fantastic, that actually worked. Thank you =]