Forum Discussion

Vapebear

Aspirant

Apr 16, 2023

Solved

Netgear ReadyNas New User - Setup issues

Hi,

I have recently purchased 2nd hand a Netgear READYNas Duo 2 and been able to:

Install Drives
Reset the system
Updated the Firmware to 5.3.13

If I try to access via AdminUsing Netgear Radar to access the Admin Page

But I still cannot access the drive via my Web Browser (Yes allowed the Security Certificate and get the following screen whenever I try to get into the Admin Rights:

Does anyone know if I should be updating the BIOS Software further? Or has this device really come to total "End of Life"?

Any suggestions would be welcome!

eton
Apr 16, 2023
To bypass the error message `SSL_ERROR_UNSUPPORTED_VERSION`, do this in Firefox:
Open the address: about:config
Change security.tls.version.min to 1.
Reload the page with the error message or open the address {NAS IP}/admin
I don't know how to do this i Chrome.

(Your attached attached images are not visible.)

5 Replies

Replies have been turned off for this discussion

eton
Luminary
Apr 16, 2023
To bypass the error message `SSL_ERROR_UNSUPPORTED_VERSION`, do this in Firefox:
Open the address: about:config
Change security.tls.version.min to 1.
Reload the page with the error message or open the address {NAS IP}/admin
I don't know how to do this i Chrome.

(Your attached attached images are not visible.)
- StephenB
  Guru
  Apr 16, 2023
  eton wrote:
  I don't know how to do this i Chrome.
  
  You can't. But both Internet Explorer and Edge in IE mode will work. More info is in this thead:
  
  https://community.netgear.com/t5/New-ReadyNAS-Users-General/Workaround-for-ERR-SSL-VERSION-OR-CIPHER-MISMATCH-problem-for/m-p/2198243
  
  Vapebear once you regain access, you can install this add-on:
  
  https://github.com/rdynsxtrs/r5bin/blob/master/apache2/Apache2_2.2.34-arm-0.0.1.bin
  
  That will install TLS 1.2 on your NAS, so you won't need to continue with FireFox.
- Vapebear
  Aspirant
  Apr 22, 2023
  Thank you for the solution - I have now been able to access the drive and start the set up process 🙂
  - eton
    Luminary
    Apr 22, 2023
    Glad it worked.
    
    You can also have a look at the other solution where you install an add-on.
    
    Now I can see your attached images. Maybe the forum needed some time to process them.