Wont boot after 6.10.0 update

Question

Upgraded rn314 to 6.10.0
Like the last os upgrade, it hangs partially booted
Power cycle a few times, always gets stuck at a different percent, until it finally completes
.
No hardware problems in the gui log.
&nbsp;
2 raid 1
Higest df = 75%&nbsp;
&nbsp;
Do you think if I buy a new chassis that will fix it?
&nbsp;

olest · Answer

I had the same problem - boot never finished after upgrade.
I could ssh to the NAS and tried to reboot several times.
I fixed it with ssh to the nas, downloaded the firmware and flashed again.
Here are the commands:
cd /root
wget http://www.downloads.netgear.com/files/GDC/READYNAS-300/ReadyNASOS-6.10.0-x86_64.zip
unzip ReadyNASOS-6.10.0-x86_64.zip
echo /root/ReadyNASOS-6.10.0-x86_64.img &gt; /etc/.flash_update
reboot

Sandshark · Answer

Mine does that a lot, and also sometimes hangs before completely shutting down when I re-boot or power down (making the liklihood of not coming back up higher).&nbsp; When it finally comes back up, it seems the OS partition (md0) is always re-syncing (which you can only see from SSH, not the GUI).&nbsp; I always assumed that was because I "pulled the plug" to try again during a critical write operation.&nbsp; But maybe it's related to the root cause?&nbsp; Perhapos it's making it's way down the list of OS partitions (it's a RAID1, but made up of a duplicate partiton on all of the drives) on each re-try until it finds a "good" one.

additude · Answer

Hello,
&nbsp;
See if this article will help you recover.
&nbsp;
Recovery-Tool-ReadyNAS-OS-6-storage-system

StephenB · Answer

I wouldn't do USB recovery at this point, because the system is eventually booting.&nbsp; So it doesn't seem likely that this is related to corruption of the flash.
&nbsp;
You should download the full log zip file from the admin web ui.&nbsp; Then ask a Netgear mod (for example,&nbsp;JohnCM_S&nbsp;) or perhaps&nbsp;Hopchen&nbsp;(former Netgear) if they are willing to analyze them for you.&nbsp; Put the log zip into cloud storage (google drive, dropbox, etc), and send the link in a Private Message (PM) to them.&nbsp; Don't post a link to the logs publicly here.&nbsp; The PM facility is reached using the envelope icon on the upper right of the forum page.

Hopchen · Answer

I agree with StephenB&nbsp;
This sounds like something else. Feel free to send me logs as per his instructions. Cheers

Forum Discussion

Wont boot after 6.10.0 update

8 Replies

Related Content

RN312 fails to come back up after update to 6.10.0

FIRMWARE UPDATE: Orbi 870 Series v10.5.20.4

ReadyNAS OS 6.10.0 (Hotfix 2) - problems after update from 6.9.5

M4250 driver update issue

ReadyNAS OS 6.10.0 Virusscanner

NETGEAR Academy

ProSupport for Business