Forum Discussion

Tutor

Mar 03, 2017

RN314 backup to USB disk: can't access target

Hi there, I have a problem with very basic backup jobs. I put up some jobs and added a few of them to the backup-button. I connect a disk to one of the USB ports. The disk is recognized, and I ...

ReadyNAS Backup

crazy_toy

NETGEAR Expert

Mar 06, 2017

Hi el_patron

what's the firmware runnning on your nas and what exactly did you edit on the backup job ?

thanks!

el_patron
Tutor
Mar 06, 2017
The firmware is 6.6.1.
In the end I change nothing on the backup job, just opening it, clicking through the tabs and closing it again is enough, to make it run afterwards...
- JennC
  NETGEAR Employee Retired
  Mar 06, 2017
  Hello el_patron,
  
  Which USB port were you using when you got the problem? Have you tried or are you getting the same problem when using other USB ports?
  
  Regards,
  - el_patron
    Tutor
    Mar 07, 2017
    I'm using one of the USB3-ports on the backside, with an extension cable to bring a connector to the frontside. Hmmh... can test with and without the extension cable and also the other port on the backside... and come back again.