Forum Discussion

Luminary

Dec 27, 2015

RNP 6 w/ Xeon CPU and upgraded fans

Changes made to keep RNP 6 cool after upgrading to Xeon CPU: OS: 6.4.2 Beta 1 Installed/Modified: Delta 80x15mm PWM EFC0812DB, 48.8 CFM, 3800 RPM, 41 dBA Noctua 120x25mm 3-pin NF-F12 Ind...

ReadyNAS OS 6 on Legacy models

walshlink

Luminary

Dec 28, 2015

Probably was...when I upgraded fans, I probably eff'd it up...so yes, blow/suck air IN...

viperhansa
Virtuoso
Dec 28, 2015
Hi guys...
If i only want to speed up system fan minimum rpm's? Is that possible?

// Hans
- mdgm-ntgr
  NETGEAR Employee Retired
  Dec 28, 2015
  You could run the echo command walshlink mentioned earlier in the thread or a similar one. His example sets the minimum fan speed to 2000 RPM.
  - viperhansa
    Virtuoso
    Dec 28, 2015
    mdgm wrote:
    You could run the echo command walshlink mentioned earlier in the thread or a similar one. His example sets the minimum fan speed to 2000 RPM.
    Hi mdgm,
    
    But that will set both fans to minimum 2000 then?
    My cpu temp is good but my system temp is a bit high. So i just want to raise that abit.
    
    // Hans