NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Step by Step instruction/help
I just purchased me a used ReadyNas Pro 4 with 4 - 4TB hard drives allready installed. I have been trying for the past 2 days to try and get it to be seen on the Readcloud but it keeps saying I have no Devices Registered or Shared even though I can see it as being registered in my Netgear Account and after using Raidar, Which see it and loging using the IP adress to configure (Both My T.V;s can see it and my PC can see it under Network storage, Media devices, and Computer(I put some Music and a couple of vids and T.V Plays them) but am wanting to be able to connect while out and about so figured I need the Readycloud.
So from the research I have done it seem I need to instal OS6 and upgrade the Memory to at least 2GB can someone Please give me a Step by Step Tutorial on How to do this and also I need to upgrade Memory to at least 2Gb but read it can handle 4GB I would need to know what kind I need would like to do 4GB if possible. My NAS is a Neatgear ReadyNas pro 4 Model: RNDP4000
44 Replies
Replies have been turned off for this discussion
Step by step for OS-6 conversion:
(Optionally) make sure the latest BIOS is installed before you do the conversion. To do this you install http://www.readynas.com/download/addons/x86/4.2/BIOS_Update_Package_0.5-x86.bin as an add-on and reboot the NAS. Do this after you backup the NAS. This isn't necessary, but if you do want to update the bios it is easiest to do it prior to conversion
Basic instructions for the conversion itself are
- BACKUP, BACKUP, BACKUP
- Upload PREPR4TOR6_0.1-x86.bin as an add-on using the ReadyNAS web gui, but do not reboot afterwards (avoids the need to do manual factory resets)
- Upload R4toR6_6.9.5.bin using the ReadyNAS web gui firmware update
- After you upload the addon+firmware and reboot, it will update the firmware and start a factory default.
- Go through the setup process on the converted NAS
- Update the NAS to the current OS 6 (check for updates will work).
- Restore files from the backup.
There is a small risk that the process could fail, and if that were to happen it might not be possible to get the NAS running again.
As far as RAM goes, the Pro4 only has one memory slot and it uses DDR2 RAM. While there are some 4 GB modules that will work, most of them won't - and the ones that do are very expensive. I recommend sticking with 2 GB. Any 240 pin PC2-6400 DDR2 ram module will work, and you should be able to find something suitable for ~20 USD or less.
I see you saying Back Up what am I backing up nothing on the Hard drives except the music and the vids I put on to test or is there something else to back up
Yoda3647 wrote:
I see you saying Back Up what am I backing up nothing on the Hard drives except the music and the vids I put on to test or is there something else to back up
Any files you have on the NAS now will be deleted during the process. So "back up" means "back up anything you want to keep on the NAS".
I realize in your case the NAS is likely near-empty, but it's important that anyone reading this instructions understand the need to back up/restore the files.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
