NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
System hang, fan issues with 6.4.x on Pioneer Pro, Ultra 6 Plus
I have a pair of 6-bay legacy ReadyNAS units here (a Pro Pioneer and an Ultra 6 Plus), both of which have been hardware upgraded to match the same spec (E7600, 8GB RAM, 6x3TB Seagate ST3000DM001) and...
Good question.
Switch is configured for LACP approprlately and the bonded interfaces show up in the switch configuration appropriately. I don't see a setting for Layer 3+4 on the switch side, but as I said this seemed to be working fine for many many months before I moved to 6.4.2 RC1, never noticed a hiccup.
The switch in question is an HP ProCurve 1800-24G, if that makes a difference to you (sorry, not a Netgear!). I can't find any specifics yet online about Layer 3+4 support, and it's been a while since I configured that, so I don't remember what basis I made that choice on. I can switch it over to Layer 2 if you think it might make a difference.
Okay, it's only a layer 2 switch like i thought, so I've changed the bond over to layer 2 for the hashing. Not sure why I had it setup all those months as layer 3+4, or for that matter why it's only now started to cause problems, but I'll change it up and go from there. Hopefully this solves it and no more hangs...
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
